LM258AYDT

Les images sont à titre de référence seulement

LM258AYDT

IC OPAMP GP 2 CIRCUIT 8SOIC

100% original & Nouveau

24 heures prêtes à expédier

Garantie 365 jours

RFQ et Obtenez plus de rabais

Spécifications

Supplier STMicroelectronics
Package Tape & Reel (TR),Cut Tape (CT)
Series Automotive, AEC-Q100
ProductStatus Active
AmplifierType General Purpose
NumberofCircuits 2
SlewRate 0.6V/µs
GainBandwidthProduct 1.1 MHz
Current-InputBias 20 nA
Voltage-InputOffset 1 mV
Current-Supply 700µA (x2 Channels)
Current-Output/Channel 40 mA
Voltage-SupplySpan(Min) 3 V
Voltage-SupplySpan(Max) 30 V
OperatingTemperature -40°C ~ 105°C
MountingType Surface Mount
Package/Case 8-SOIC (0.154, 3.90mm Width)

Vue d'ensemble

Description

LM258AYDT is a Texas Instruments dual general-purpose operational amplifier (an LM258/LM358-family device) in a single package. It is designed for low-power, single-supply operation and common in signal conditioning and buffering tasks.
Key points:
- Dual op-amps in one 8-pin package; two independent amplifiers (A and B).
- Not rail-to-rail; input common-mode includes the negative rail; output can swing close to ground but won’t reach the positive rail.
- Wide single-supply voltage range (typical from a few volts up to about 30–32 V).
- Low quiescent current and relatively low input bias, suitable for battery-powered apps.
- Typical uses: sensor conditioning, active filters, voltage followers, summing/integrator circuits.
Pinout (8-pin package, common for LM358/LM258): V+, V−, Out A, In+ A, In− A, In− B, In+ B, Out B (check exact package variant).
Packaging: AYDT denotes a specific TI package/temperature variant; verify the exact package (DIP-8, SOIC-8, etc.) and temperature grade in the datasheet.

Features

LM258AYDT features:
- Dual general‑purpose operational amplifiers in one package
- Wide supply range: 3 V to 32 V (single supply) or ±1.5 V to ±16 V
- Unity‑gain stable
- Input common‑mode range includes the negative rail
- Output can swing toward the negative rail (ground) but is not rail‑to‑rail
- Not rail‑to‑rail on input or output
- Typical gain‑bandwidth around 1 MHz; moderate slew rate
- Low input bias current and low input offset voltage
- Temperature range: wide (commonly −40 °C to +125 °C)
- Available in 8‑pin packages (DIP/SOIC variants)
Note: exact numbers (GBW, offset, bias) vary by device revision and manufacturer tolerances; check the current datasheet for precise specs.

Package

LM258AYDT comes in an 8-pin Small Outline Integrated Circuit (SOIC-8) surface-mount package.

Pinout

- Pin count: 8 pins
- Function: Dual operational amplifier (two independent op-amps). Each op-amp has a non-inverting input, an inverting input, and an output. Typical pinout (DIP/SOIC-8):
1 = Output A
2 = Inverting input A
3 = Non-inverting input A
4 = V– (GND)
5 = Non-inverting input B
6 = Inverting input B
7 = Output B
8 = V+ (Vcc)

Manufacturer

Manufacturer: Texas Instruments (TI).
What kind of company: TI is an American multinational semiconductor company that designs and manufactures analog, mixed-signal, and embedded processing ICs; it acquired National Semiconductor, the original source of the LM258 family.

Application

LM258AYDT is a dual general‑purpose op‑amp. Typical application areas include:
- Single‑supply signal conditioning and buffering (3–32 V)
- Audio preamplifier and line‑driver stages
- Active filters (low/high/band‑pass), tone controls
- Amplifiers for sensors/transducers (gain, offset, level shift)
- Inverting/non‑inverting, summing, differential amplifiers; integrators/differentiators
- ADC/DAC front‑ends and feedback control loops
- Servo regulators, power‑supply monitoring, instrumentation circuits

Equivalent

Direct equivalents (pin-for-pin):
- LM358 (dual op-amp; same pinout)
- LM2904 (dual op-amp; pin-compatible)
- LM258/LM258A (same family; variant packaging)
Notes: These can replace LM258AYDT in many designs, but verify supply voltage, input/output swing, and rail requirements for your circuit. Non-identical substitutes (e.g., LMV358) may have different specs.

Expédition

Méthodes d'expéditionNous

offrir des services d'expédition mondiaux par DHL, FedEx, TNT, UPS ou tout autre expéditeur de votre choix.


Référence des frais d'expédition (DHL/FedEx):

DHL: Les frais d'expédition vont de 25 à 45 $ (0,5 kg), avec un délai de livraison estimé de 2 à 5 jours ouvrables.

FedEx: Les frais d'expédition varient de 25 à 40 $ (0,5 kg), avec un délai de livraison estimé de 3 à 7 jours ouvrables.

UPS: Les frais d'expédition vont de 25 à 45 $ (0,5 kg), avec un délai de livraison estimé de 3 à 7 jours ouvrables.

TNT: Les frais d'expédition varient de 25 à 65 $ (0,5 kg), avec un délai de livraison estimé de 3 à 7 jours ouvrables.

EMS: Les frais d'expédition varient de 30 à 50 $ (0,5 kg), avec un délai de livraison estimé de 7 à 15 jours ouvrables.

Courrier aérien enregistré: Le coût d'expédition est de 2 à 4 $ (0,1 kg), avec un délai de livraison estimé de 5 à 20 jours ouvrables.

Paiements

Payment Methods

Le terme de paiement est 100% prépayé.

Actuellement, nous n'acceptons que les méthodes de paiement ci-dessous:

1. PayPal

2. Carte de crédit/débit

3. Transfert bancaire

Similaire